Insertion Of The Crimping Die; Assembly Steps - HARTING 09 99 000 0990 Betriebsanleitung

HARTING Battery crimping tool 09 99 000 0990
NOTICE
Released
Fixed (II)
Opened (I)

8.1.2 Insertion of the crimping die

As a standard, the battery crimping tool
09 99 000 0990 is equipped with a die for
processing crimped contacts of the Han D
E and Han C series. The contacts may
® ®
have a maximum diameter of 4 mm. To pro-
cess larger contacts, a Han
for conductors with cross-sections of 4, 6 or
10 mm² is available.
Ⓐ
Ⓒ
Ⓓ
Ⓑ
Ⓒ
Ⓒ
Ⓓ
Ⓓ
16
Positions of release lever
The lever for triggering the crimping process can take
three different positions:
Stage III (upper position):
(III)
Stage II (mid position):
Stage I (lower position):
,
®
C crimping die
®
①
②
Han C
®
4 – 10 mm²
Standard
crimping die closed, crimping
process starts
crimping die mechanically clo-
sed, contacts can be inserted
crimping die opened
The installation of the crimp die is descri-
bed using the example of the standard
crimp die for this tool. From the rear, de-
pending on the type of contact, a special
positioner must be inserted to ensure a
uniform processing quality for the various
crimp contacts (➱ Chapter 8.2 Crimping).

Assembly steps

WARNING!
ready-to-use battery crimping tool
can be released accidentally.
▸ Always disconnect the battery before
you insert or remove the crimp die!
1. Loosen the fixing screws Ⓐ+Ⓑ from the
tool head.
2. Insert the die (Ⓒ+Ⓓ) that is suitable for
your type of contact in the specified posi-
tions of the tool (⇨ red arrows). Check if
the crimping die is correctly seated while
the release lever is in position II.
Note: The crimping die is correctly aligned
if the inscriptions are legible and not
upside down (⇨ Ⓒ+Ⓓ).
HARTING Electric GmbH & Co. KG
Risk of cru-
shings: The