Electrical Installation To A Permanent Connection - clage CDX 7-U Montageanleitung Für Den Fachhandwerker

CDX 7-U / CDX 11-U
7. Electrical connection
EN
Alternative:

Electrical installation to a permanent connection

If, in case of particular local circumstances, connecting to a permanent connection is
the only possibility, continue as follows.
1. Disassemble the pre­installed power cable.
2. Dismantle off the power cable so that you can insert the cable with the cladding
through the water splash protection sleeve up to the cord grip into the appliance.
3. Lead the cable through the water splash protection sleeve into the appliance so that
one can securely fix the cladding of the cable with the cord grip. If necessary, use
one of the three predetermined breaking points for the cable entry (at the right, left
or bottom). The protective sleeve prevents water from entering the appliance along­
side the connection line. The protection sleeve has to be used!
4. Mount the cord grip. The cord grip must be used!
5. Strip the cables and plug them in the connecting terminals according to the wiring
diagram. The appliance must be earthed.
6. After successful electrical connection, fit the hood of the unit. Make sure not to jam
any cables between the appliance hood and the base part of the appliance.
16