24
Installation Guide
Dial-up access within two minutes: the RAS wizard
The setup wizard starts automatically on completion of the Basic Settings Wizard.
If the wizard does not start automatically, call it up with Tools
Select the 'Provide Dial-In access (RAS)' option.
The wizard briefly requests the required data (teleworker's name, password and
telephone number as well as network addresses). Thereafter, the company network
is ready to be accessed from within the home office.
Step by step: which settings do you configure on the router?
Menu
Setup/WAN-module
Setup/WAN-module/Layer-list
Setup/WAN-module/Name-list
Setup/WAN-module/PPP-list
Setup/WAN-module/PPP-list/
Default
TCP/IP
Setup/IP-router-module
networks only
TCP/IP
Setup/IP-router-module/
IP-routing-table
networks only
ELSA LANCOM Office Router
Parameter
Comment or value
Protect
'Name' protects the local network from calls
from unknown origins.
WAN-layer
'TELEWORK': name of the new layer being
used for dial-up access.
Encaps.
'Trans'
Lay-3
'PPP'
Lay-2
'Trans'
L2-Opt.
'compr.'
Lay-1
'HDLC64k'
Device-name
'TELE01': name of the teleworker who is to be
given access to the LAN.
Time Out
'0': the teleworker can determine the duration
(B1-DT, B2- DT)
of the connection.
WAN-layer
'TELEWORK': layer configured for RAS
access.
Device-name
'TELE01': as defined in the Name list.
Authent.
'PAP': password protection using the
Password Authentication Protocol
Key
'*': indicated by asterisks when typing into
the PPP list.
Time
'0': for home offices operating under
Windows
Authent.
'PAP': this setting must also be used for the
default entry.
Proxy-ARP
'On': allows the router to route data to
destinations that actually are located on the
same logical network.
IP-address
'10.0.0.99': address that will be assigned to
the teleworker for the duration of connection.
Must be on the same subnet as the router.
IP-netmask
'255.255.255.255': the corresponding subnet
mask.
Setup Wizard.
Configures the new layer to
the values that are necessary
for normal PPP access.