Erasing Recorded Data; How To See How Much Recording Capacity Remains - Korg EC350 Bedienungsanleitung

To pause the song, press the PAUSE button. The song will pause at that location and
the PAUSE LED will go on.
Press either the START/STOP or the PAUSE button to resume playback.
Playback will also stop when all the recorded data is played back, and the START/
STOP LED indicator will turn off.
Note: If you press the PAUSE button during playback, and then switch to recording
at the location where you paused, recording may not always begin correctly from
the paused location.
Adjusting the balance between the two parts.
PART 2 simultaneously, you can hold down the TOUCH button and press the button
(either PART 1 or PART 2) of the part whose volume you wish to decrease.
To restore the original volume balance, hold down the TOUCH button, and simulta-
neously press both the PART 1 and PART 2 buttons.
Repeatedly playing back the performance.
song play back repeatedly (loop).
During playback, press the TRANSPOSE/FUNCTION button. The TRANSPOSE/
FUNCTION LED will blink, and the song will playback repeatedly.
To cancel the repeating playback, press the START/STOP button.

Erasing recorded data

While playback is stopped, hold down the TRANSPOSE/FUNCTION button, and
1
press either the PART 1 or PART 2 button. The LEDs of the TRANSPOSE/FUNC-
TION button and either the PART 1 or PART 2 buttons will blink, and the EC350
will be ready to erase recorded data.
If you press the TRANSPOSE/FUNCTION button once again, you will exit erase-
standby mode.
Press either the PART 1 or PART 2 button to erase the performance data.
2

How to see how much recording capacity remains

You can see how much memory has been used for recording on each separate track.
Turn on the LED on the button of the Part whose memory amount you want to
1
check. For example, if you want to see how much memory has been used for Part 1,
turn on the LED of the PART 1 button.
The recorder
When playing back PART 1 and
You can make the entire recorded
31