Second-Pass Recording; Playing Back Your Recorded Performance - Korg EC350 Bedienungsanleitung

If you press the PAUSE button, recording will pause at that location, and the PAUSE
LED will light.
To resume recording, press the REC button, press the PART1 (or PART2) button,
then play on the keyboard.
Note: Recording may not always begin correctly from the paused location.

Second-pass recording

After recording, you can enter recording again, and start overdubbing on the already
recorded data of a part. New data will be added to the older ones.
Press the START/STOP button to begin playback.
1
When you reach the point where you wish to re-enter recording, press the PAUSE
2
button.
Press the REC button. The LED on the button will light.
3
As during the first recording, press either or both PART 1 or PART 2 (depending on
4
the part(s) that was previously recorded), to select the part(s) that you wish to
record. This will make the LED blink for the part(s) that you wish to record.
Note: An empty part cannot be recorded at this point. You can only select already
recorded parts.
Start playing on the keyboard, to automatically begin recording.
5
When finished recording, press the START/STOP button to stop the recorder.
6

Playing back your recorded performance

After recording, you can play back your recorded performance.
If there is recorded data, the LED(s) of the PART 1 and/or PART 2 buttons will
1
light. You can press the button for a part that you do not wish to hear, making its
LED turn off so that the part will not play back.
Press the START/STOP button to begin playback. During playback, the START/
2
STOP LED will blink in time with the time signature, a longer light on the first beat,
and a shorter one on other beats.
You can use the TEMPO slider to adjust the playback tempo. Changing the song
tempo will not affect the pitch.
To stop playback, press the START/STOP button. The song will stop and automati-
3
cally return to the first measure.
30
Chapter 5