Korg EC350 Bedienungsanleitung Seite 48

Place the stand, which is now partially assembled, on the ground, with the outer part
5
of the leg panel resting on the floor. Fit the right side panel (A) to the pedal beam
(C). Insert two long bolts (b) into the two holes at the end of the pedal beam, from
the inside of it, and tighten up the bolts.
Turn the stand over so that the feet touch the ground. Fix the rear panel (D) to the
6
stand, with the unpainted side facing the rear part. Attach the rear panel to the
unpainted side of the stand, using the nine screws (a). First, screw all screws (with-
out tightening) by following the numbering order (a1, a2 ... a9), then tighten them
by following the same numbering order.
a1
a5
a3
46
D
a8
a7
C
a2
a6
a9
a4
A
b
Chapter 8