Midi Data Dump - Korg EC150 Bedienungsanleitung

MIDI Data Dump

You can save the current sound settings (Single or Layer mode) on an external MIDI
storage device, like a sequencer or a MIDI data filer. You can later reload these data
into the EC150, to restore a saved set of data.
Warning: To avoid loosing data, read carefully read the owner's manual of your
MIDI data filer.
Hint: To avoid any trouble, don't forget to deactivate System Exclusive data recep-
tion on the connected device.
The following table shows which data are saved with the Data Dump.
Category
Single mode
Layer mode
Saving data to the data filer.
Use a MIDI cable to connect the EC150 MIDI OUT to the MIDI IN of the data filer.
1
Prepare the data filer to receive MIDI data.
2
On the EC150, hold down the TRANSPOSE/FUNCTION button, and press the
3
VIBES/GUITAR sound selection button. The LEDs of the TRANSPOSE/FUNC-
TION and VIBES/GUITAR buttons will blink, indicating that the EC150 is ready to
transmit the data dump.
Press the TOUCH button. The data dump will begin, and the sound setting data will
4
be transmitted to the data filer.
During a data dump operation, the EC150 will not produce sound, and no other
function will work. When the data dump is completed, you will return to normal
playing condition.
You may cancel a data dump operation before the data dump begins, by pressing the
TRANSPOSE/FUNCTION or VIBES/GUITAR button.
Loading data from the data filer.
ously saved on a data filer.
Use a MIDI cable to connect the MIDI IN of the EC150 to the MIDI OUT of the
1
data filer.
MIDI
Data
Reverb and chorus settings (on/off status, send level)
Reverb and chorus settings (on/off status, send level),
balance between sounds, damper pedal on/off status
for each sound.
Here is how to save the data of the EC150.
You can load into the EC150 data you previ-
35