Troubleshooting; Weak Batteries; Command Not Confirmed - eQ-3 homematic IP Evo Montage- Und Bedienungsanleitung

Troubleshooting

8 Troubleshooting
8.1

Weak batteries

Provided that the voltage value permits it, the radiator
thermostat will remain ready for operation also if the bat-
tery voltage is low. Depending on the particular load, it
may be possible to send transmissions again repeatedly,
once the batteries have been allowed a brief recovery
period.
If the voltage drops too far during transmission, the emp-
ty battery symbol (
will be displayed on the device (see "8.4 Error codes and
flashing sequences" on page 60). In this case, replace
the empty batteries by two new batteries (see "7 Replac-
ing batteries" on page 56).
8.2

Command not confirmed

If at least one receiver does not confirm a command, the
device LED (D) lights up red at the end of the failed trans-
mission process. The failed transmission may be caused
by radio interference (see "11 General information about
radio operation" on page 63). The failed transmission
may also be caused by the following:
• Receiver cannot be reached.
• Receiver is unable to execute the command (load
failure, mechanical blockade, etc.).
• Receiver is defective.
58
MANU
BOOST
) and the corresponding error code
C