eQ-3 homematic IP Evo Montage- Und Bedienungsanleitung Seite 46

Start-up
You can manually start the teach-in mode for
another 3 minutes by pressing the system button
(D) briefly (see fig. 4). If the display is off, a short
press on the system button is needed to activate
the teach-in mode. Once the display shows "
" and you press the system button again, the
adaptation run starts. This behaviour can be
ignored at this stage. For further information see
"5.3 Adaption run" on page 54.
• Your device will automatically appear in the
Homematic IP app.
• To confirm, enter the last four digits of the device
number (SGTIN) in your app or scan the QR code.
Therefore, see the sticker supplied or attached to
the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED (D) lights
up green. The device is now ready for use. If the
LED lights up red, please try again.
• In the app, give the device a name and allocate
it to a room.
Slide the battery compartment cover (C) back on
•
from the bottom upwards (see fig. 5).
46
MANU
BOOST
C