Use; Using The Product Without A Power Connection; Corded Use Of The Product - Parkside PASL 4000 B2 Bedienungs- Und Sicherheitshinweise

Note: Charge the product at least once a month, if
it is to remain unused for an extended period of time.
Note: If the product has not been charged for an
extended period of time (approx. 2 months), you
could find that the integral rechargeable battery
has entered a dormant state. Charge and discharge
the product a number of times in succession to
reactivate the integral rechargeable battery.
Note: You can choose to charge the product directly
via the mains adaptor
12
Before charging, switch the product off (press
ON / OFF switch
3
To charge the product via mains adaptor
directly, remove the red rubber cover at the back
of the product, connect the USB cable
the USB connector of the mains adaptor
and then connect the USB (type C) connector
on the USB cable
11
socket of the LED torch.
6
To charge the product via the charging station,
connect the USB cable
tor of the mains adaptor
the USB (type C) connector on the USB cable
to the USB (type C) input socket of the
11
charging station
10
into the charging station to charge the product
(see fig. B).
Note: The power indicator of the charging
station will turn to red light when electrical
9
power is connected. It will light up red contin-
uously until the power is disconnected.
Note: The product is fitted with an overcharge
protection circuit. Despite this, you should dis-
connect the LED inspection lamp from the power
supply after the charging process is complete.
Note: The green charging indicators (LED torch)
will light up and flash during charging. There
4
are 4 indicator lights showing the charging
progress (approx. 25 % / 50 % / 75 % / 100 %).
When the indicator continually light on mean
the represented charging progress was finished.
When charging is complete, all indicator light
out of the socket. Disconnect the mains adaptor
from the product to prevent the rechargeable
battery from discharging.
or via the charging station.
).
12
with
11
12
to the USB (type C) input
with the USB connec-
11
and then connect
12
. Then place the product

Use

CAUTION! RISK OF ACCIDENT! Always
store and secure the product in such a way that there
is no risk of injury from or damage to the product.
Note: The product may be secured with the fold-
out hook or by securing it to a flat, ferromagnetic
5
surface using the magnetic base
at the back. You can tilt the product up to 180 °
7
on the magnetic base
CAUTION! Please note the position of your hands
whilst turning the magnetic base
pinching your fingers (see Fig. D).
Using the product without
a power connection
Fully charge the product as described in the
section "Charging the product".
The product can be operated in 4 different
modes, select these by:
Repeatedly pressing the ON / OFF switch
Press once:
Press twice:
Press three times: Switches the side light
Press four times:

Corded use of the product

Use the included mains adaptor
pose. Using the respective mains adaptor
connect the product to a suitable power supply.
Then proceed as described under "Using the
product without a power connection" (starting
with step 2).
Note: The product can only be charged
whilst off!
12
or the magnet
8
.
8
to prevent
8
The side light lights up
2
with white light.
The side light turns to
2
UV light mode.
off and switches on the
spotlight .
1
Switches off the product.
for this pur-
12
GB
.
3
2
,
12
9