Unlocking The Control Element; Calibrating The Height Display - sedus temptation c smart/speed Bedienungsanleitung

6.3.4 Unlocking the control element

This function unlocks control elements with memory function which have been locked against accidental
activation. Proceed as follows to unlock the control element:
LOC
LOC
69.8

6.3.5 Calibrating the height display

The height notification on the display (optional) may occasionally deviate slightly from the actual desk
height. Proceed as follows to calibrate the height display:
AST
or
AST
1. If LOC is shown on the display, the control element is locked against any
activation.
2. Press and hold the memory button for at least 8 seconds. During this time,
LOC is still shown on the display.
3. You can release the memory button as soon as the desk height is shown on
the display again. The control element is now unlocked.
1. Use the "down" button to move the desk into its bottommost position. Then
press the "down" button again for at least 5 seconds.
"RST" is now shown, flashing, on the display.
2. Now press and hold the memory button until the height of the desk is shown,
flashing, on the display.
3. Now set the right desk height on the display by pressing the "up" or "down"
button.
After approx. 5 seconds of no button being pressed, "RST" is shown, flashing, on
the display.
Now press the "down" button again until the desk moves down slightly and then
up again. Only release the button once the desk has stopped moving. If the
button is released too soon, this causes a desk malfunction. If the button was
released early by accident, you must repeat the reset process as described in
Section 5.
72