Before Installation, Uninstallation Or Troubleshooting; Before Putting The Desk Into Operation; During Operation - sedus temptation c smart/speed Bedienungsanleitung

Danger: The motorised desk may not be used in an explosive atmosphere!
Danger: If an error occurs, the desktop may start to move every time height adjustment is
triggered before the safety shutdown is engaged. Note that there is a potential crushing hazard
in this situation.
Danger: During all reset processes (Section 5), the integrated collision protection is not active.
Note that there is a potential crushing hazard in this situation.
Danger: When setting up the table, the moving parts should have a minimum distance of 25
mm to all surrounding objects (furniture, walls, etc.).
Caution: If the product is visibly damaged, it must not be assembled or used again!

1.5.2 Before installation, uninstallation or troubleshooting

•
Stop the desk.
Note: Switch off the power supply and unplug the mains cable!
• Remove any weight from the desk.
•
The electrical equipment may only be opened or replaced by a qualified electrician.
• Do not operate the desk in damp places such as bathrooms.
•
The desk may not be used in potentially explosive atmospheres.

1.5.3 Before putting the desk into operation

•
Ensure that the desk was assembled in compliance with these instructions.
• Check whether the desk's operating voltage corresponds to the local power supply.
(See nameplate on the control unit, standard = 230 V)
•
Establish plug connections from the operating unit and the side elements to the control unit.
•
Plug in the control unit's mains cable.

1.5.4 During operation

•
If the drives or the control unit emit(s) unusual noises or odors during operation, disconnect the power
supply.
• Ensure that the cables are not damaged.
•
Care must be taken to ensure that no objects or body parts can get caught when the desk is in operation.
• All moving parts of the desk must be at a distance of at least 25 mm from adjacent components.
•
Electrical wiring must not be exposed to a crushing hazard, bending load or tensile load.
48