General Information; Abbreviations And Subject Index; Scope Of Delivery - BWT bestaqua 16 ROC Einbau- Und Bedienungsanleitung

1 General information

1.1

Abbreviations and subject index

Softening:
Raw water:
RO:
Permeate:
Concentrate:
Membrane:
TDS:
SDI:
Electrical conduc-
tivity:
IOM:
Water conversion
factor (WCF):
Bypass setting with
cold drinking water:
1.2

Scope of delivery

The BWT bestaqua 16 ROC includes the following components:
RO filter cartridge bestaqua 16 ROC Membrane
Installation and operating instructions
Connection material: Drain connection (DN50), permeate adapter JG 8 mm x M3/8" and F3/8"
x M3/4", 1.5 m hose JG 8 mm, connection cable for the electricity supply (type F/type I/type
G)
Refer to the images on the inside cover:
1 RO filter cartridge bestaqua 16 ROC Membrane
1
2 Status LED
3 Top service cover
The following connections are seen on the rear of the BWT bestaqua 16 ROC:
4 Socket for PE adapter type IEC 320
5 Device ON/OFF switch
2
6 Drain connection 8 mm JG (5/16")
7 Connection for feed water M 3/4"
8 Connection for permeate 8 mm JG (5/16")
9 Serial number and technical data
Top view
Removing the top service cover provides access to the integrated filter head with female thread
for insertion of the filter cartridge:
3
10 Filter head for the bestaqua 16 ROC Membrane with bypass adjustment
A pre-treatment process that removes the hardness from the raw water. The
hardness is caused by the calcium and magnesium ions contained in the
water.
The raw water is the untreated drinking water that is connected to the
connection for the water inlet.
Reverse osmosis.
The largely desalinated "pure water extracted through reverse osmosis". The
key parameter is the electrical conductivity in μS/cm or TDS.
The waste water that contains all the salts and minerals removed from the
raw water.
The device's filter, which desalinates the raw water under high pressure and
throughput.
Total dissolved solids: total content of dissolved salts, measured in mg/l.
Silt density index
(blockage index)
tendency to cause a blockage.
The lower the value for electrical conductivity
RO device, the lower the salt concentration in the permeate product.
Installation and operating manual
The ratio between the quantity of pure water produced
waste water
(concentrate)
Using the bypass setting on the blue setting mixer head
, an amount of cold drinking water can be added to the pure water
service cover)
produced. The BWT bestaqua 16 ROC enables continuous adjustment of the
bypass independent of locking position 0, 1, 2, 3).
: The silt density index is a measure of water's
produced.
or TDS measured by the
(μS/cm)
and the
(permeate)
(at the top of the device below the
13