General Safety Instructions; Intended Use; Technical Data; Reasonably Foreseeable Misapplication - SCHUNK KSC 80-Serie Montage- Und Betriebsanleitung

_________________________________________________________________________________________
2

General safety instructions

2.1 Intended use

The clamping device may only be used in accordance with the technical data and has been
designed for stationary application on milling machines in an industrial environment.
Using the device in accordance with the intended purpose includes compliance with the
commissioning, installation and operating instructions, and with the environmental and
service conditions as provided by the manufacturer.
The manufacturer accepts no liability for damage resulting from non-intended use.

2.1.1 Technical data

Version
KSC 80 L-130
KSC 80 L-190
Exposure to loads in excess of the max. pull-in torque results in damage to the spindle.
Weight:
KSC 80 L-130 incl. reversible jaws grip:
KSC 80 L-190 incl. reversible jaws grip:
For further data, please see the current catalogue >> Schunk stationary Workholding <<
The declaration of conformity can be found in the appendix to these operating instructions.

2.2 Reasonably foreseeable misapplication

Any application that is not in accordance with the "Intended use" or exceeds such
intended use is considered not in accordance with the regulations, and is forbidden.
Any other use of the device is subject to confirmation from the manufacturer.
Examples of forseeable misapplication:
 Clamping device used on rotating systems.
 Clamping widely protruding workpieces.
 Clamping workpieces with a weight of over 20 kg in vertical position without an additional
safeguard to prevent the workpiece falling out.

2.2.1 Alterations and modifications

In the case of unauthorised alterations and modifications of the clamping device,
the manufacturer's liability ceases and any warranty is voided.

2.2.2 Spare and wear parts and auxiliary material

Only use original parts or parts approved by the manufacturer.
Using spare and wear parts by third party manufacturers may lead to risk.
schunk.com
All manuals and user guides at all-guides.com
max. max.
torque clamping force
90 Nm 25 kN
90 Nm 25 kN
XND.00022.002_B – 10/2018
4.0 kg
5.5 kg
17