C.fn: Setting Custom Functions; Protection Functions - Hahnel MODUS 600RT MKII Bedienungsanleitung

C.Fn: Setting Custom Functions

The following table lists the available and unavailable custom functions
of this flash.
1. Software Version
Press <Zm/C.Fn> Backlight/Custom Setting Button for 2 seconds
or longer until C.Fn menu is displayed. The "Ver x.x" in the topright
corner refers to the software version.
2. Select the Custom Function No
• Turn the Select Dial to select the Custom Function number
3. Change the Setting
• Press <SET> button and the Setting No. blinks.
• Turn the Select Dial to set the desired option. Pressing <SET>
button will confirm the settings.
• After you set the Custom Function and press function button 4, the
camera will be ready to shoot.
4. C.Fn Default
In the C.Fn menu, a long press of the "Clear" button for 2 seconds
until "OK" is displayed on the panel, which means the values in C.Fn
are reset to their default options

Protection Functions

1. Over-Temperature Protection
• To avoid overheating and deteriorating the flash head, do not fire
more than 30 continuous flashes in fast succession at 1/1 full power.
After 30 continuous flashes, allow a rest time of at least 10 minutes
• If you fire more than 30 continuous flashes and then fire more
flashes in short intervals, the inner over-temperature protection
function may be activated and make the recycling time over 10
seconds. If this occurs, allow a rest time of about 10 minutes, and
the flash unit will then return to normal
• When the over-temperature protection is active, <
on the LCD display
Modus 600RT
> is shown
33