Flash Output Power Range; Optical O1 Secondary Unit Setting; Optical O2 Secondary Unit Setting; Flash Mode: Multi Flash - Hahnel MODUS 600RT MKII Bedienungsanleitung

Flash Output Power Range

The following table makes it easier to see how the stop changes in
terms of f/stop when you increase or decrease the flash output.
For example, when you decrease the flash output: 1/2, 1/2-0.3, or 1/2-
0.7, or increase the flash output:1/2, 1/2+0.3, 1/2+0.7, 1/1.
Figures displayed when reducing flash output level→
1/1-0.3
1/1
1/2+0.7
←Figures displayed when increasing flash output level

Optical O1 Secondary Unit Setting

In M manual flash mode, press <O1/O2> button so that this flash can
function as an optical O1 secondary flash using its optical sensor. With
this function, the flash will fire synchronously when a second main flash
fires. This is the same effect as usng a radio trigger to fire the flash off
camera. This helps create multiple lighting effects.

Optical O2 Secondary Unit Setting

In M manual flash mode, press <O1/O2> button so that this flash can
function as an optical O2 secondary flash using its optical sensor. With
this function, the flash will fire synchronously when a second main flash
fires as in O1 but it will ignore the metering pre-flash and fire only in
response to the exposure flash from the main unit.
• O1 and O2 optic triggering is only available in M manual flash mode.

Flash Mode: MULTI Flash

With stroboscopic flash, a rapid series of flashes is fired. It can be used
to capture multiple images of a moving subject in a single photograph.
You can set the firing frequency (number of flashes per sec.expressed
as Hz), the number of flashes, and the flash output power.
18
SET
1/1-0.7
1/2
1/2+0.3
1. Press < MODE > button so
that < M > is displayed
2. Turn the Select Dial to
choose a desired flash output
amount
3. Press < SET > button again
to confirm the setting
1/2-0.3 1/2-0.7
1/4+0.7 1/4+0.3
------
1/4
------
Modus 600RT