Using Automatic Wireless Flash With Multiple Slave Units; Adavnced Setting With Fully Automatic Wireless Flash - Hahnel MODUS 600RT MKII Bedienungsanleitung

Using Automatic Wireless Flash with
Multiple Slave Units
When stronger flash output or more convenient lighting operation
is needed, increase the number of slave speedlight's. To add slave
units, use the same steps as setting "automatic wireless flash with
a single slave unit" (Page 25). Any slave speeedlight can be set as
group (A/B/C).
When the number of slave units is increased or the master flash firing
is set to ON, automatic control is performed to fire all flashes at the
correct flash output to ensure that the total flash output results in the
standard exposure.
• If the slave unit's auto power off takes effect, press the master unit's
test flash button to turn on the slave unit. Note that the test flash cannot
be performed while the camera's metering timer, etc. is operating
• The slave units auto power off setting can be changed (C.Fn-Sv / APOT
page 33)
• In the C.Fn settings you can enable a beeper to sound when a Modus
600RT is recharged and ready to fire again
Advanced setting with fully automatic wireless
flash
With the wireless system the following functions set on the master unit
will automatically be adjusted on the slave unit. For this reason you
do not need to operate the slave unit (s) and can operate it from the
master in the same way as normal flash photography.
• Flash Exposure Compensation <
• Flash Exposure Bracketing <
• FV Lock: Flash Value Lock (Page 17)
• High-Speed Sync <
• Manual Flash (Page 17)
• MULTI Flash (Page 18)
Modus 600RT
6 Check the Master slave
speedlight operation
• Press the master unit's <
test button
• The slave speedlight will
flash. If it does not fire, check
the position or distance of
slave from master
• You are now ready to take a
photo with the wireless flash
lighting
> (Page 17)
FEB
> (Page 17)
> (Page 16)
>
25