Calcualting The Shutter Speed; Number Of Flashes / Flash Frequency = Shutter Speed - Hahnel MODUS 600RT MKII Bedienungsanleitung

Calculating the Shutter Speed
During stroboscopic flash, the shutter remains open until the firing
stops. Use the formula below to calculate the shutter speed and set it
on the camera.
Number of Flashes / Flash Frequency
= Shutter Speed
For example, if the number of flashes is 10 and the firing frequency is 5
Hz, the shutter speed should be at least 2 seconds.
• To avoid overheating and deteriorating the flash head, do not use
stroboscopic flash more than 10 times in succession
• After 10 times, allow the speedlight to rest for at least 15 minutes. If you
try to use the stroboscopic flash more than 10 times in succession, the
firing might stop automatically to protect the flash head. If this happens,
allow at least 15 minutes' rest for the speedlight
• Stroboscopic flash is most effective with a highly reflective subject
against a dark background
• Using a tripod and a remote control is recommended.
• A flash output of 1/1 and 1/2 cannot be set for stroboscopic flash
• Stroboscopic flash can be used with"buLb"
• If the number of flashes is displayed as "--", the firing will continue until
the shutter closes or the battery is exhausted. The number of flashes
will be limited as shown by the following table.
Maximum Stroboscopic Flashes:
Modus 600RT
SET
1. Press <MODE> button so
that < MULTI > is displayed
2. Turn the Select Dial to
choose a desired flash output
power
3. Set the flash frequency and
number of flashes
• Press <
Times
• Turn the Select Dial to set
the number of flashes
• Press the <
• Turn the Select Dial to
choose a desired flash firing
frequency
• After you finish the setting,
press <SET> button and all
the settings will be displayed.
> button
>
H
Z
19