Spare Parts - Heiniger Saphir Originalbetriebsanleitung

Malfunction
The control light
of the charging
station in not on
When battery is
unloaded the light
does not change
from green to red
LED flashes alter-
nately red / green
8

Spare parts

See illustration spare parts at the end of this instruction manual.
WARNING!
Faulty spare parts may cause damages, malfunctions or total loss and may
reduce security. Therefore:
Only use original spare parts from the manufacturer. Purchase the spare
X
parts at the official distributor or directly at the manufacturer.
If using no original spare parts all warranty and service claims are ex-
X
piring.
Pos. No. Description
1 Complete housing set
3 Battery
4 Motor complete
5 PCB shearer
6 Rubber tap
7 Turning lever
8 Seal
9 Circlip
10 Washer
11 Eccentric cogwheel, pre-assembled
14 PT-screw Kombitorx KA30x16
15 Blade support
16 Blade interlock
17 PT-screw Kombitorx KA30x8
18 Clipping pressure spring
19 Blade guidance
18
Cause
Charging station is not
connected to the power
supply
Charging station is faulty Have charging station inspected (S)
Contacts of battery and/
or charging station are
dirty
Faulty battery
Contacts of the charging
station are deformed
Faulty battery
Translation of the original instructions / Small animal clipper
Rectification
Connect the charging station to
the power supply
Clean contacts
Replace battery
Have the charging station re-
paired (S)
Replace battery. Individually
test batteries if two batteries are
inserted into the charging station
at the same time.
Quantity
1x
1x
1x
1x
1x
1x
1x
1x
1x
1x
12x
1x
1x
1x
1x
1x