Kenwood SoupEasy+ CBL30 Bedienungsanleitung Seite 18

Troubleshooting Guide
Problem
'End' shown and
flashing on screen.
Unit beeping.
'----' shown on
screen.
'OPEN' shown and
flashing on screen.
Unit beeping.
'JUG' shown and
flashing on screen.
Unit beeping.
Error Codes
E0 - E5 shown on
screen and unit
beeps.
If the problem persists contact your nearest authorised Kenwood Service Centre.
To find up to date details of your nearest Kenwood Service Centre visit
www.kenwoodworld.com or the website specific to your country.
Cause
Smooth or Chunky Soup
programme in the keep
warm mode.
Cold blending cycle
reached 3 minutes
and unit automatically
stopped.
Preset finished or
cancelled.
Standby mode.
Lid not fitted.
Lid removed or open
during processing.
Goblet not fitted.
Goblet removed during
processing.
Heater or motor
overload/overheat issues.
(Thermal cut out
operated).
Insufficient liquid in
recipe and goblet has
boiled dry.
Goblet overloaded.
Solution
Normal Function.
To stop the Keep Warm mode turn
the dial to '0' position.
To reselect the speed press 'Start'
or to stop turn the dial to 'O'.
It is recommended to allow the
blender to cool down for 15 minutes
if you want to operate for more
than 3 minutes at a time.
Turn the dial to 'O' or press 'Start' to
reselect a preset.
Normal operation.
Select speed or preset.
Fit lid and press 'Start'.
Fit goblet and press 'Start'.
Unplug and wait a few seconds until
the screen goes blank.
Then plug back in to reset.
Before restarting check that
sufficient liquid is being used.
Check that sufficient liquid added.
Follow the advice in this manual
and reduce processing quantities if
exceeding the recommendations.
12