Taking Measurements; Mi70 First Start-Up Settings; Basic Measuring Steps With Dm70 - Vaisala DRYCAP DM70 Kurzanleitung

3 Taking measurements
3.1 MI70 first start-up settings
When taking MI70 into use for the first time, configure the basic settings (language, date, and
time) as instructed below.
1. Press the Power On/Off button in MI70 to switch the indicator on.
2. Press any of the arrow buttons and open the menu by pressing
3. Select Settings using the
4. Select User interface and press
5. Select Language and press
6. Select the language using the
7. To set the date, return to the Settings menu by pressing
8. Select Date and press
selection, press
To select an alternative date format, select Date format and press Set. You can select from
3 alternative formats. Press Select to confirm the selection.
9. To set the time, return to the Settings menu by pressing
10. Select Time and press
selection by pressing
If you want to use the 12-hour clock, select 12-hour clock and press
11. To return to the basic display, press
3.2 Basic measuring steps with DM70
If measuring in a pressurized process, see
Before taking measurements, make sure that the air pressure settings of DM70
are correct and that autocalibration has taken place. See
settings (page 13)
1. Remove the yellow transport protection cap from the probe head.
12
buttons and press
.
Set.
buttons. Confirm the selection by pressing
Set. Change the date using the
Select.
Set. Change the time by using the arrow buttons. Confirm the
OK. As a default, the time format is based on the 24-hour clock.
Exit.
and Autocalibration (page
Open.
.
.
buttons. To confirm the
Sampling cells (page
Configuring pressure
14).
M212551EN-B
Select.
On.
15).