Programming The Autosteamer Temperature - B; Programming The Temperature While Frothing Milk; Programming The Group Cleaning Mode Cln - C; Regulating The Pre-Infusion - D, Pre-Infusion Volume - E And Pre-Infusion Time - F - ECM Manufacture Compact HX-2 PID Bedienungsanleitung

5.2.3a Programming the autosteamer temperature - b
Setting range:
Open the main menu by pressing the ECM button and button no.3. Press button no. 1 or 2 until you reach
the menu item b. Confirm with the ECM button.The current set temperature is indicated on the display.
Select the desired temperature using buttons no. 1 or 2.
The recommended temperature is 66° C.
To confirm the selected temperature, press the ECM button. Now you are back in the main menu.
5.2.3b Programming the temperature while frothing milk
Keep the ECM button pressed until the light above the button starts to flash.
Place the steam wand of the autosteamer in a filled milk jug and press the autosteamer button. Steam will
begin dispensing with the temperature displayed on the right control panel. Once the desired temperature
is reached, press the autosteamer button again to save the value. To exit the programming press the ECM
button.
Risk of injury
Always keep the steam nozzle underneath the surface of the liquid in order to avoid being
sprayed.
Avoid skin contact with the steam dispenser while cleaning!
Important
After every application, clean the steam nozzle and the steam dispenser with a non-
abrasive, damp cloth. This removes any liquid residues.

5.2.4 Programming the group cleaning mode Cln - c

The control panel allows the programming of a reminder for the next brew group cleaning.
There is no preset reminder when the machine is delivered, so please program the reminder as desired:
Open the main menu by pressing the ECM button and button no.3. Press button no. 1 or 2 until you reach
menu item c and select by pressing the ECM button.
The reminder will be activated on the display when the programmed number of extractions has been
reached. Please select a number of extractions by pressing the buttons no.1 or 2.
Setting range: 1-99 >1 is equivalent to 100 extractions
An extraction is ony counted as such after 15 seconds. Therefore, a flush or every extraction
under 15 seconds is not counted.
Example: If you have programmed the number 5, the display will remind you (indicating „Cln") to clean the
brew group. Learn more about the automatic brew group cleaning in chapter 7.2.
5.2.5 Regulating the pre-infusion – d, pre-infusion volume – E and pre-infusion time - F
During pre-infusion, the coffee grounds are dampened prior to the espresso extraction and slowly well up.
This makes the coffee puck more stable and keeps it from being destroyed by the high brewing pressure.
Furthermore, the oils and aromas are able to develop prior to extraction.
You can choose between three settings that affect the pre-infusion volume E and the pre-infusion time F.
Pre-infusion – d:
00 = off, no pre-infusion
01 = pre-infusion through pump
02 = pre-infusion through the water pressure
pre-infusion volume – E:
pre-infusion time – F:
Translation of the original German user manual
→ pre-infusion volume and pre-infusion time are inactive
→ pre-infusion volume and pre-infusion time can be
programmed
→ only the pre-infusion volume can be programmed
setting range (0.0 – 5.0 sec)
setting range (0.0 – 5.0 sec)
ENGLISH
26