Product Delivery; General Advice; General Safety Notes - ECM Manufacture Compact HX-2 PID Bedienungsanleitung

1

PRODUCT DELIVERY

1 portafilter with coffee filter - 1 spout
2 portafilters with coffee filter - 2 spouts
1 blind filter
2 drip grids to raise the espresso cups
1 flexible hose for fresh water supply: 3/8" for connection waterpipe, 150 cm
1 drainage hose, 150 cm
2

GENERAL ADVICE

2.1 General safety notes

• Make sure that the local main supply voltage corresponds to the information given on the
type plate on the front panel of the espresso machine.
• Carry out the installation of the machine according to the instruction in chapter 4.
• Plug the machine into a grounded socket only and do not leave it unattended.
• Do not roll or bend the power cord.
• Do not use an extension cord/ do not use a multiple socket.
• Place the machine on an even and stable surface. You can regulate the height of the
machine by adjusting the feet of the machine.
• Never place the machine on hot surfaces.
• Never immerse the machine in water; do not operate the machine with wet hands.
• The machine should only be used by experienced adult persons.
• The machine is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• The machine should be installed by a skilled person.
• Do not expose the machine to inclement weather (frost, snow, rain) and do not use it
outdoors.
• Keep the packing out of reach of children.
• Only use original spare parts.
• Do not operate the machine with carbonated water, but with soft potable water.
• Do not operate the machine without water.
If you have any further questions or if you require any further information, please contact your specialised
dealer before starting up the espresso coffee machine.
Our machines comply with the relevant safety regulations.
Any repairs or changes of single components must be carried out by an authorised specialty dealer. If the
supply cord is damaged, it must be replaced by the manufacturer, its' service agent or similarly qualified
persons in order to avoid a hazard.
In case of non-observance, the manufacturer does not assume liability and is not liable for recourse.
Ask for authorised service points outside of Germany.
Important
When necessary, make use of a water softener / water filter cartridge in order to reach an
adequate hardness degree. If these measures are insufficient, a prophylactic descaling of
the machine is possible. Contact your specialised dealer before undertaking this measure.
ENGLISH