Individual Coffee Machine Settings - eta Latteria 4180 Bedienungsanleitung

GB
PREPARATION OF CAPPUCCINO AND LATTÉ MACCHIATO
You can prepare cappuccino and latte macchiato using the pre-set automatic programs
(buttons B6 and B7). It is also possible to use the method of preparation using a separate
milk frothing function (button B5).
You can use the E4 rotary knob to set the ratio between the amount of hot milk and milk
foam:
– If you want more milk foam, turn the E4 knob to the right.
– If you want more hot milk, turn the E4 knob to the left.
Using pre-set automatic programs:
1. Switch on the coffee machine by pressing button B1 and wait for it to warm up.
2. Fill the D container with water and the E container with milk.
3. Fill the stainless-steel bowl (C1/C2) with ground coffee to the brim with a measuring
cup G. Smother the coffee properly with the stamper (back of the measuring cup G)
intended for this purpose.
4. Place the lever C on the coffee machine as shown in Fig. 3.
5. Press the B6 button (final beverage volume will be approx. 137 ml) or B7 button (final
beverage volume will be approx. 273 ml) The indicator light of the relevant button will
flash during preparation.
6. Wait for the beverage preparation to complete (an acoustic signal sounds).
Preparation of Cappuccino and Latté Macchiato using a separate milk frothing
function:
1. Switch on the coffee machine by pressing button B1 and wait for it to warm up.
2. Fill the D container with water and the E container with milk.
3. First, prepare the coffee using the classic method (see paragraph ESPRESSO
PREPARATION).
4. Then press the B5 button. The indicator light of the B5 button will flash during
preparation.
5. Wait for the milk to froth (an acoustic signal sounds).
V. INDIVIDUAL COFFEE MACHINE SETTINGS
INDIVIDUAL SETTING - ESPRESSO
The amount of coffee can be adjusted for both one cup (32-48 ml - button B2) and two
cups (62-78 ml - button B3). The procedure is as follows:
1. Switch on the coffee machine by pressing button B1 and wait for it to warm up.
2. Fill the container D with water.
3. Then press and hold the B2/B3 button (an acoustic signal sounds) until the required
amount of coffee flows out. When the required amount of coffee has flowed, release the
button pressed (an acoustic signal sounds).
4. The setting will be saved in the coffee machine memory and will remain stored even
after the coffee machine is switched off and unplugged. network.
If you hold the B2/B3 button too short, your settings will not be saved.
Note
Remark
26 / 55