Light Indication; Maintenance - eta Latteria 4180 Bedienungsanleitung

INDIVIDUAL SETTING - CAPPUCCINO AND LATTÉ MACCHIATO
The amount of coffee can be set between 32-48 ml and the amount of milk (foam) can be
set between 105-165 ml / 247-373 (B6/B7). The procedure is as follows:
1. Switch on the coffee machine by pressing the B1 button and wait for it to warm up.
2. Fill the D container with water and the E container with milk.
3. Press B6/B7 and wait for the milk foam to start flowing. Then press and hold the
appropriate button (an acoustic signal sounds). When the required amount of foam
has flowed, release the button pressed (an acoustic signal sounds). Then wait until the
coffee starts to flow. Then press and hold the appropriate button again (an acoustic
signal sounds). When the required amount of coffee has flowed, release the button
pressed (an acoustic signal sounds).
4. The settings will be saved in the coffee machine's memory and will remain saved even
after the coffee machine is switched off and disconnected from the power supply.
INDIVIDUAL ADJUSTMENT OF MILK AMOUNT
The amount of milk (foam) can be set between 128-195 ml. The procedure is as follows:
1. Switch on the coffee machine by pressing the B1 button and wait for it to warm up.
2. Fill the D container with water and the E container with milk.
3. Then press and hold button B5 (an acoustic signal sounds) until the required amount of
milk (foam) flows (an acoustic signal sounds).
4. The settings will be saved in the coffee machine's memory and will remain saved even
after the coffee machine is switched off and disconnected from the power supply.
FACTORY SETTING RESET
If you wish to cancel the coffee machine settings that you have modified, you can return it to
the factory setting. The procedure is as follows:
1. Switch the coffee machine off by pressing the B1 button.
2. Press and hold the B2 and B3 buttons at the same time. Then switch the coffee machine
on while holding both buttons by pressing the B1 button. The indicator light on the
control panel flashes and an acoustic signal sounds..
3. Release the B2 and B3 buttons.
4. Now the factory setting of the coffee machine is restored.
VI. LIGHT INDICATION
Marking Colour
B8 red
B9 yellow
VII. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord out
of the socket (except for operations which require the coffee machine to remain
switched on)! Clean the appliance only when it is cooled down! Do not use rough
and aggressive detergents (e.g. sharp objects, scrapers, diluting agents or other
solvents)! Wipe the surface of the appliance and its inlet with a damp cloth.
Status
flashing There is no water in the container.
stably The coffee machine is damaged, contact an
lighting authorized service centre.
Warning of the need to descale the coffee machine.
flashing See Chapter VII. MAINTENANCE for the descaling
procedure.
27 / 55
Meaning
GB