Using The Appliance - eta Latteria 4180 Bedienungsanleitung

– If possible, use only fresh whole milk.
– It is also possible to use alternative types of milk (soy, almond, etc.) with a label
"Barista"..
– Make sure that the E6 milk hose is correctly positioned.
Removing operational components
Looking at the camera that is used more often with the coffee machine (metal lever C, drip
tray F), proceed as shown in Fig. 1. Proceed in reverse order to put the components back.
Rinsing the coffee maker
When using the coffee machine for the first time or if you have not used the coffee machine
for more than 2 days, first rinse it with clean water. The procedure is as follows:
1. Fill containers D and E with water.
2. Place lever C correctly in place.
3. Place a suitable container under the coffee spout and the milk nozzle.
4. Press and hold button B4 (for approx. 3 seconds) and wait for the first cleaning step to
complete.
5. Then press the B4 button again, but this time briefly and wait for the second cleaning
step to complete.
IV. USING THE APPLIANCE
– Pressing any button is accompanied by an acoustic signal.
– When making coffee, the coffee machine automatically has a coffee brewing function
that cannot be switched off.
– The heating of the coffee machine is indicated by the flashing of the light signalling of
buttons B2-B7. The light in button B1 illuminates red.
– If you remove the milk container E, only the espresso function (buttons B2 and B3) can
be used.
– Automatic shut-off after 30 minutes of inaction.
PREPARATION OF ESPRESSO
1. Switch on the coffee machine by pressing button B1 and wait for it to warm up.
2. Fill the container D with water.
3. Fill the stainless-steel bowl (C1/C2) with ground coffee to the brim with a measuring
cup G. Smother the coffee properly with the stamper (back of the measuring cup G)
intended for this purpose.
4. Place the lever C on the coffee machine as shown in Fig. 3.
5. Place a suitable size cup / cups under the coffee spout.
6. Press button B2 (for one cup - factory setting 32 ml) or button B3 (for two cups - factory
setting 62 ml). The indicator light of the relevant button will flash during preparation.
7. Wait for the coffee to finish (an acoustic signal sounds).
– For an optimum coffee making process and better taste of your coffee, we recommend
that you preheat your cup by filling it with hot water first (e.g. using the hot water
function). After the cup has been preheated, pour the water away.
– You can use the heating surface A1 to warm up the cup for your coffee.
Notes
Remarks
Cup preheat
25 / 55
GB