Changing The Nip Bars From Reverse To Standard Setting - FAS Euroline Bedienungsanleitung

Changing the nip bars from
reverse to standard setting
When running in reverse (menu choice
DIRECTION REVERSE in menu F5), the metal
bar and the rubber bar has to be interchanged.
This procedure dscribes how the nip bars is
changed from reverse back to normal. Proceed
as follows:
1 Loosen both handles on the shaft. See Fig.
42 (Note! reverse mounting is shown)
2 Loosen the screws holding the bar to the
axle, remove the bar and withdraw the axle.
See Fig. 44
3 Turn the axle 180° and insert it again.
4 Loosen the screws for the fixed bar and
move the bar to the axle. Note that the bar
now is positioned "upside-down".
5 Take the bar removed in item 2 and mount
it on the fixed bar's position. Fasten the
screws and tighten.
6 Mount back both handles.
June 2014
CF-unit
Fig. 42 Loosen the handles
Fig. 43 Loosen the screws holding the bar
Fig. 44 Loosen the bar and withdraw the
axle
BW / U 900 44