Changing The Brushes On The Sealing Bars - FAS Euroline Bedienungsanleitung

Changing the brushes on the
sealing bars
• Remove the sealing bars and place them on a
table.
• Remove the screw and the U-shaped holder.
• Gently pull out the old brush and disconnect
the cable from the isolation plate.
• Insert a new brush and connect the cable to
the isolation plate.
• Place the U-shaped holder and fasten the
screw. Do not overtighten.
June 2014
CF-unit
Brush
Screw
U-shaped holder
Fig. 29
BW / U 900
Seal wire holder
Screw
Isolation plate
39