Checking The Variator Belt - FAS Euroline Bedienungsanleitung

Checking the variator belt

The variator belt should be tensioned to ensure
that no slipping occurs during operation. Adjust
the belt tension by moving the bearing housing
with the tensioning screws. See Fig. 17.
Note The belt must run straight between the
belt pulleys and not lie against any of
the bearings.
Remark!
Belt slip can also be caused by grease or oil
on the variator belt pulley. Clean these and
also the variator belt with a suitable cleaning
and degreasing agent before tensioning the
belt.
Shock absorber, dancing roller
A hydraulic shock absorber for the lower end
position is fitted on the dancing roller's bearing
housing.
• Check regularly to make sure that there is a
gap of 1 mm between the point of the shock
absorber and the shock absorber housing in
order to achieve efficient shock absorbing.
• Adjust the gap by loosening the lock nuts and
turning the adjuster screw. See Fig. 18
June 2014
CF-unit
Fig. 17
Fig. 18
BW / U 900
1 mm
35