FAS Euroline Bedienungsanleitung Seite 33

Set "preheat" to "on"
Choose "Preheat level" in % of your production
seal heat.
This will be the heat that the seal bars will keep
in standby while changing master roll or during
a short production stop. (Initial setting 50%).
Choose "Preheat time" in seconds for standby
duration. During this time the seal bars will be
heated to the pre set level. (initial setting is 300
sec.)
Choose "Seal heat delay" in seconds. When
pushing the start button, the seal heat will go to
100%, and after the chosen seal heat delay the
machine will start.
Activate
Press F6 to activate the preheat. The F6 LED
will flash.
Note If the preheat time is exceeded during
a stop, the preheat function has to be
activated again by pressing F6.
June 2014
Settings and adjustment
BW / U 900
Preheat
Preheat level
Preheat time
Sealheat delay #-
Fig. 4 Sub menu from Preheat
settings in menu F4
on
#- %
#---s
s
29