8 Attach a new teflon ribbon over the silicon
rubber. Replace the double sided tape if
necessary.
Note
No teflon is needed under the sealwire
if using seal leadge.
9 Put a new seal wire in place and fasten the
allen screw.
10 Make sure that you press the seal wire
holders towards each other when fastening
the last screw, to keep the seal wire pre-
tensioned.
11 Fasten the teflon ribbon with double sided
tape.
June 2014
CF-unit
Fig. 25
Fig. 26
Fig. 27
Fig. 28
BW / U 900
38