Servo motor timing belts
In order to adjust the tension, the special tool
supplied with the machine must be used.
• To adjust belt tension, the support angle plate
for servo motor is mowed sideways. Loosen
the three hex-head bolts and move plate. The
seal section drive has a set screw, the
perforator drive has none. Proper tension is
when belt can be pushed down 5 mm
between pulleys. Tighten the three hex-head
bolts again.
June 2014
CF-unit
Fig. 15
Fig. 16
Warning!
!
The knives in the bag machine have
sharp edges. To avoid the risk of
personnel injury, all personnel must
exercise extreme caution when
handling the perforator blades.
BW / U 900
34