Checking Of Belt Tension, Drive Motor; Setting Of Fingers In Horizontal Position; Adjusting The High Speed Nip - FAS Euroline Bedienungsanleitung

Checking of belt tension, drive
motor
The belt is correctly tensioned when it can be
pressed down 3-5 cm between the belt pulleys.
Adjust the belt tension by loosening the motor's
attaching screws and moving the motor. Refer
to Fig. 39.
Setting of fingers in horizontal
position
The horizontal positioning of the web catching
fingers is set as follows:
1 Set the main switch to the ON position.
2 Set the "mode selector" to the left position
to lift the dancer up.
3 Press the "start machine" button twice to
make a mnual roll change.
Check to make sure that the fingers start to
function and are in the correct position (the
grooves shall be in "web flow" direction). To
adjust, loosen the screws holding the fingers,
turn the fingers and re-tighten the screws.

Adjusting the high speed nip

The high speed up is adjusted with the knob, see
Fig. 41.
June 2014
CF-unit
Fig. 39 Belt tension drive motor
Fig. 40 Operating panel
Fig. 41 Adjusting of high speed nip
BW / U 900
2
3
43