FAS Euroline Bedienungsanleitung Seite 35

CF-unit
Outside sealing section
The drive chains are governed by a resilient
chain tensioner. See Fig. 7.
Adjust the chain tension if so required by
altering the spring tension with the help of the
adjuster screw.
Fig. 7
Outside cooling section
The tension in the drive chains is automatically
controlled by a sprocket on an arm, spring
loaded in a clamping arm.
With the correct tension in the chain, the arrow
on the arm points at an angle of approx. 20° in
relation to the clamping arm, see Fig. 9
Adjust the tension, if necessary, by loosening
the screw on the rear and turning the clamping
arm with a spanner (36 mm) until the correct
tension is obtained. Tighten the screw.
Fig. 8
Fig. 9
June 2014 BW / U 900 31