Changing The Seal Wire - FAS Euroline Bedienungsanleitung

Changing the seal wire

Note When exchanging the seal wire, teflon
and silicon for new items, they must
be exchanged on all sealing bars at
the same time.
1 Remove the sealing bars and place them on
a table.
2 Peel off the teflon ribbon. The ribbon is
fastened with double sided tape on the sides
of the sealing bar.
3 Loosen the two allen screws and remove
the old seal wire. Loosen the first screw
carefully since the seal wire holders are
spring loaded to keep the seal wire
tensioned at all times.
4 Peel off the next teflon ribbon if using
silicon rubber. This ribbon is also fastened
with double sided tape on the sides of the
sealing bar.
5 Remove the silicon rubber or the seal ledge.
6 Place a new silicon rubber or the seal ledge
inside the aluminium bar. See Fig. 23.
7 When using silicon rubber. Press firmly
into groove/channel, chamfer each end at
approx 45°. See Fig. 24.
June 2014
CF-unit
Seal wire
Teflon ribbon
Fig. 21 Sealing bar with silicon rubber
Seal wire
Teflon ribbon
Fig. 22 Sealing bar with seal ledge
Fig. 23 Place silicon rubber/seal ledge
Fig. 24 Press silicon rubber/seal ledge
BW / U 900
Silicon rubber
Allen screw
Double sided tape
Sealing bar
Seal ledge
Allen screw
Double sided tape
Sealing bar
37