Technical Data; Installation; Fitting Under A Counter - Electrolux ESF 45030 Benutzerinformation

After the check, switch on the appliance. Set
the knob on the same washing programme
as before the malfunction.
The programme continues from the point of
interruption. If the malfunction shows again,
contact your Service Force Centre.
These data are necessary to help you quickly
and correctly:
The dishes are not clean
Limescales particles on the
dishes
The dishes are wet and dull
There are streaks, milky spots
or a bluish coating on glasses
and dishes
Dry water drop signs on
glasses and dishes

Technical data

Dimensions
Electrical connection - Voltage -
Overall power - Fuse
Water supply pressure
Capacity

Installation

Fitting under a counter

Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Put the appliance adjacent to a water tap and
a water drain. Remove the appliance work-
top to install it under a sink unit or a kitchen
The cleaning results are not satisfactory
• The selected washing programme is not applicable for the type of
load and soil.
• The baskets are loaded incorrectly so that water cannot reach all
surfaces.
• Spray arms do not turn freely because of incorrect arrangement of
the load.
• The filters are dirty or not correctly installed.
• The quantity of detergent is too little or missing.
• The salt container is empty.
• The water softener is adjusted on a wrong level.
• The salt container cap is not closed correctly.
• No rinse aid has been used.
• The rinse aid dispenser is empty.
• Decrease the rinse aid dosage.
• Increase rinse aid dosage.
• The detergent can be the cause.
Width cm
Height cm
Depth cm
Information on the electrical connection is given on the rating plate
on the inner edge of the dishwasher door.
Minimum
Maximum
Place settings
• Model (Mod.)
• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........
worktop. Make sure that the dimensions of
the recess agree with the given dimensions.
electrolux 37
45
85
63
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
9