Operation-/Work Instructions; Electrical Connection - Scheppach AB1900 Originalbetriebsanleitung

Stop continuous operation: Press and re-
lease operating switch.

10. Operation-/work instructions

Caution! For your safety, the machine
must be held only at the two handles (3
and 5, Fig. 1)!
This will avoid the danger of an electric
shock through contact of lines during chis-
elling.
Always keep the chiselling tools sharp.
Note:
• Work only at low pressure when chisel-
ling.
• Excessive pressure loads the motor un-
necessarily.
• Sharpen the chisels in time and replace,
if necessary.
Dust/Chip Extraction
Dusts from materials such as lead-con-
taining coatings, some wood types, min-
erals and metal can be harmful to one's
health. Touching or breathing-in the dusts
can cause allergic reactions and/or lead
to respiratory infections of the user or by-
standers.
Certain dusts, such as oak or beech dust,
are considered as carcinogenic, espe-
cially in connection with wood-treatment
additives (chromate, wood preservative).
Materials containing asbestos may only
be worked by specialists.
• Provide for good ventilation of the work-
ing place.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Heruntergeladen von manualslib.de Handbücher-Suchmachiene
• It is recommended to wear a P2 fil-
ter-class respirator.
Observe the relevant regulations in your
country for the materials to be worked.

11. Electrical connection

The electrical motor installed is con-
nected and ready for operation. The
connection complies with the applica-
ble VDE and DIN provisions. The cus-
tomer's mains connection as well as
the extension cable used must also
comply with these regulations.
Faulty power supply cables
Insulation damage often occurs at power
supply cables.
Causes are:
• Pressure points when power supply ca-
bles are routed through the window or
door gaps.
• Bends due to improper fastening or
guiding of the power supply cables.
• Interfaces by running over the power
supply cables.
• Insulation damage by pulling off the wall
outlet.
• Cracks due to ageing of the insulation.
Such defective power supply cables must
not be used and are extremely dangerous
to life because of the insulation damage!
Check power supply cables regularly for
damage. Make sure that the power cable
is not connected to the mains supply when
you check.
GB | 29