Assembly - LIVARNO LUX LSHB 150 B1 Bedienungsanleitung Und Serviceinformationen

LIVARNO LUX LSHB 150 B1

7.4. Assembly

 Detach the wall bracket (7) from the outdoor halogen spotlight by
removing the 2 screws (2) with a Phillips screwdriver. Note that the
wall bracket (7) is attached on both sides with a screw (2), a spring
washer and a nut. Keep these parts safe until you are ready to
assemble them.
 Use the wall bracket (7) as a template to mark the two holes.
 Then drill the two holes and attach the wall bracket (7) using the
supplied wall plugs and screws or, depending on the installation
location, using other suitable plugs and screws.
 Open the cable junction box (3) by loosening the four screws using a
Phillips screwdriver and removing the cover.
 Loosen the 2 screws on the strain relief within the cable junction box
(3) with a Phillips screwdriver only to the extent that the power cable
(11) can be subsequently fed through it.
 Loosen the screw connection (5) of the cable bushing (4), but do not
completely unscrew it.
 Remove approx. 5 to 8cm of the sheath of the power cable (11).
 First, route the power cable (11) through the screw connection (5)
and the cable bushing (4), and then through the strain relief in the
cable junction box (3). When routing the power cable (11) through
the cable bushing (4), an internal rubber seal must be penetrated. A
slight resistance may thus be felt.
 Fix the power cable (11) by tightening the 2 screws on the strain relief
within the cable junction box (3). The end of the cable sheath must be
in the strain relief for this purpose. Do not clamp the individual wires!
 Then tighten the previously loosened screw connection (5) of the
cable bushing (4) in a clockwise direction. This ensures the sealing of
the power cable (11).
12 - English