Siemens simovert masterdrives DTI Betriebsanleitung Seite 29

All manuals and user guides at all-guides.com
Installation, Connecting-up
Terminal
X402:
Table 3-1
♦ In the case of TTL encoders (X401), the signals and the inverse
NOTES
♦ If the inverted signals are not used in the case of HTL encoders,
♦ If a supply voltage of >15 V is necessary for HTL tachometers, it can
3-2
Function, information
HTL tachometer
1 Reference potential (M tachometer)
2 Pulse track A
3 Inverted pulse track A
4 Reference potential (M tachometer)
5 Pulse track B
6 Inverted pulse track B
7 Reference potential (M tachometer)
8 Position track (not evaluated)
9 Inverted position track (not evaluated)
10 Reference potential (M tachometer)
11 Tachometer monitoring track (not
evaluated)
12 Inverted tachometer monitoring track
13 Reference potential (M tachometer)
14 15 V supply
Terminals
signals of the tachometer must be connected.
these inputs must be connected at X402 with reference potential (M
Tacho) (see Fig. 5-2).
be picked off from -X404:3 and 4.
Digital tacho-Interface
11.2006
Cable cross-section
2
[mm ] AWG
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
0,5 to 2,5 20 to 14
6SE7087-6CX84-3DB0 Siemens AG
SIMOVERT MASTERDRIVES