Assigning Preset 1-3 - Canton Smart Soundbar 10 Kurzanleitung

ASSIGNING PRESET 1-3

The Soundbar 10 is able to assign three memory buttons with „presets".
Settings like volume, selected input and settings in the Speaker Setup [SPS]
menu (sound settings, etc.) as well as playlists from the app „Spotify" can be
stored. The memory buttons can be operated via the Smart remote control as
well as via the keypad on top of the Soundbar 10.
Practical tip:
• We recommend that you store the settings you have made in the loud-
speaker menu during the initial set-up of the Soundbar 10, e.g. regarding
loudspeaker levels and distances, sound settings, etc., to one of the three
preset buttons so that your settings are not overwritten by the factory
(neutral) settings if you accidentally press one of the preset buttons.
To store playlists and/or (sound)settings, please proceed as follows:
Please apply the desired settings regarding volume, sound, input, etc. and
1
press and hold the memory button 1, 2 or 3 until the corresponding num-
ber [P1], [P2] or [P3] is shown in the display and no longer flashes.
To store a playlist, please open the desired playlist on the app „Spotify" on
2
your (mobile) device and start playback. Be sure to select Spotify Connect
as your connection to Soundbar 10, not Chromecast built-in. Now, please
press and hold the corresponding memory button 1, 2 or 3 until the corre-
sponding number [P1], [P2] or [P3] is shown in the display and no longer
flashes. Storing a playlist automatically stores all (sound)settings, too.
To recall the settings resp. a playlist from these presets, please press the
3
corresponding button 1, 2 or 3 briefly. The settings are then called up, resp.
the tracks from the stored playlist are played back automatically by the
Soundbar 10 (even without using your (mobile) device).
English
3 4 3