Important Safety Instructions - Canton Smart Soundbar 10 Kurzanleitung

English

IMPORTANT SAFETY INSTRUCTIONS

Read and follow all instructions. Keep these instructions. Observe all
warnings and safety instructions. Operate this device only in a moderate
climate (not in a tropical climate). Do not operate this device at altitudes
above 2000 m above sea level. To avoid the risk of fire or electric shock, the
device must not be exposed to rain or moisture. Do not operate this device
near water. Do not expose this device to dripping or splashing water. Strong
temperature fluctuations lead to condensation (water droplets) in the
device. Wait until the moisture has evaporated (at least three hours). Do not
place objects filled with liquids (such as vases) on the device. Do not place
an open fire, such as lit candles, on or near the device. Do not place the de-
vice near heat sources such as radiators, heat accumulators, stoves or other
devices (including amplifiers) that generate heat. Avoid direct sunlight. Keep
a clearance of at least 5 cm around the device. Never prevent the protective
function of polarised or grounded plugs: A polarised plug has two pins, one
wider than the other. An earthed plug has a third earthing pin. The wide or
third pin is for your safety. If the plug does not fit into your outlet, contact a
qualified electrician to replace the obsolete outlet. To avoid electric shock,
connect the mains plug only to sockets or extensions where the contact
pins can be fully inserted to prevent exposed contact pins.
Never touch the signal and mains cable with wet hands. Do not step on or
pinch the mains cable, especially not in the area of the plugs, sockets or
where the cable is led out of the device. For devices without a mains switch,
in which the mains plug or the device mains socket serves as an isolating
device, the plug of the mains cable or the device mains socket must be
freely accessible at all times. Disconnect the device from the mains during
thunderstorms or prolonged periods of non-use. To completely disconnect
the device from the power supply, unplug the mains cable from the wall out-
let. Where the mains plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable. Always switch
off the device before connecting or disconnecting signal cables. Always
switch off the device before connecting or disconnecting signal cables.
Always pull the plugs and not the cables. Install the device according to
the manufacturer's instructions. Always choose a level surface. The device
must be in a vertical position. Do not exert force on operating elements,
connections and lines. The device may only be operated with the voltage
and frequency specified on the device or the type plate. Do not insert any
objects or body parts into the openings of the device. Live parts inside the
housing could be touched and/or damaged. This can lead to short circuits,
electric shocks and fire. Only use fixing materials and accessories that are
approved by the manufacturer and/or supplied with the device. Only use
trolleys, stands, tripods, holders or tables specified by the manufacturer or
sold with the device.
When using a trolley, be careful when moving the trolley/device
assembly to prevent damage and injury from tipping over.
Only clean this device with a clean, dry cloth. Do not use any aggressive, al-
coholic or abrasive agents for cleaning. To avoid electric shock, do not open
the housing! There are no user-serviceable parts in the device. Consult quali-
fied personnel for all repair and maintenance work. This is required when
the device has been damaged in any way, such as mains cable or plug
damage, liquid or objects have been spilled, exposed to rain or moisture,
does not operate normally, or has been dropped. Do not make any changes
to the device or accessories. Unauthorised modifications can compromise
safety, regulatory compliance or system performance. In this case, the type
approval/guarantee may expire.
28
If sound distortions such as unnatural knocking, throbbing or high-fre-
quency clicking occur during playback, the volume level must be reduced
immediately.
To avoid possible hearing damage, do not listen at high levels for
long periods of time. Interrupt the playback if you hear ringing or
whistling noises in your ears or if you have the impression that
you can no longer hear high sounds (even for a short time).
New and used batteries must be kept away from children. Devices in which
the battery compartment cannot be closed securely must not be used any
longer and must be kept away from children. The remote control supplied
with this device contains a button cell as battery. Swallowing the button
cell can cause serious internal burns and thus death in only 2 hours! Do not
ingest the battery, Chemical Burn Hazard. If you think batteries might have
been swallowed or placed inside any part of the body, seek immediate
medical attention. Take care of your environment when disposing of the
battery. Batteries must be disposed of at a battery collection point. Do not
expose batteries to high temperatures, such as direct sunlight, fire or the
like. Batteries must be inserted correctly according to the polarity imprint.
Incorrect insertion can lead to damage. Only use the batteries or rechar-
geable batteries specified for the device. The batteries supplied are not
rechargeable batteries, i.e. these batteries must not be recharged.
The device contains permanent magnets. Do not place or lay
objects that are sensitive to magnetic fields
(e.g. tube TVs, external hard drives, magnetic cards, video
cassettes, etc.) on or directly next to the device.
The device and/or the accessory may contain small parts that
can be swallowed. Therefore not suitable for children under
three years.
This symbol indicates uninsulated dangerous voltages inside the
case that are sufficiently strong (amplitude) to cause a fire or
electric shock.
This symbol warns you of important operating and maintenance
instructions in the accompanying documentation (manual)
supplied.
This symbol indicates Class II devices, where protection against
electric shock is provided by double or reinforced insulation
during specified use and therefore no protective earth
connection is required.