Dmx Operation - EuroLite LED Laser Derby MK2 Bedienungsanleitung

* Auto mode and sound-controlled mode always start with program 1.
If, for example, no strobe is desired, press the B button to switch off the strobe effect. The menu jumps to
program 3 in the display and is played back in that way.
Or, if no derby is desired, press the A button to switch off the derby effect. The menu jumps to program 4 in
the display and is played back in this way.
Derby + Strobe + Laser
Program 1
Derby + Strobe
Program 2
Derby + Laser
Program 3
Strobe + Laser
Program 4
Derby
Program 5
Strobe
Program 6
Program 7 Laser
Notes:
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with max. 9 control channels.
However, it can also be switched to a mode with 2, 4, 5, 6, 7 or 8 channels if different functions are required.
To be able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button so many times until DMX appears on the display. Confirm with the ENTER
button. The display next shows dXXX, please confirm again with ENTER.
2 The display then indicates 2 CH (2 DMX channels), 4 CH (4 DMX channels), 5 CH (5 DMX channels), 6
CH (6 DMX channels), 7 CH (7 DMX channels), 8 CH (8 DMX channels) or 9 CH (9 DMX channels).
Use the buttons UP and DOWN to select the desired DMX channel mode. Confirm with the ENTER
button.
3 For the DMX start address press the MENU button until dXXX is shown on the display. Use the buttons
UP and DOWN to set the address. Confirm with the ENTER button.
4 The red LED next to the display will blink when DMX signals are being received. If no control signals are
available, the red LED next to the display will not blink.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
34/44 00132332, Version 1.0