Interconnecting Several Devices (Master/Slave Operation); Remote Control Ir - EuroLite LED Laser Derby MK2 Bedienungsanleitung

Interconnecting several devices (master/slave operation)

Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAV is indicated on the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.

Remote control IR-16

The IR remote control allows convenient control of the integrated show programs in automatic mode or
sound-controlled mode. Press the buttons repeatedly to switch between the programs. The display indicates
the current setting. When actuating a button, always hold the remote control in the direction of the sensor at
the control unit's front or rear. There must be visual connection between the remote control and the sensor.
Note: Operation via IR remote control not possible in DMX or slave mode.
Note: Buttons A, B and C can be played together if an effect combination is desired.
Button
On/off
Auto mode: see graphic for programs 1 – 7*
Sound control: see graphic for programs 1 – 7*
Pause
Derby change of colors
Derby change of colors
Derby LED effect
Strobe effect
Laser effect
Program speed adjustment in Auto mode: 0 is lowest, 9 is highest
–
Switches between Auto mode and Sound control in A, B or C mode.
No function
Function
33/44 00132332, Version 1.0