Kurtz Ersa X-TOOL VARIO Bedienungsanleitung Seite 24

Maintenance and servicing
8.3 Clean the residual solder pot
8.3.1 Removing/installing residual solder pots
8.3.2 Replacing filter plugs
24
All manuals and user guides at all-guides.com
Caution! Burns are possible!
The residual solder pot can heat up during desoldering. Let the tool cool
down to room temperature before removing the residual solder pot.
Place a warm residual solder pot only on heat resistant surfaces.
The sintered filter disc should be cleaned respectively replaced at each filter
plug change.
3BA00215 • 2016-07-11 • Rev. 3
■
Let the tool cool down to room temperature.
■
With a rotational movement, pull the residual solder pot
out of the holder.
■
To re-install the residual solder pot, press it back into the
holder with a rotary motion until the edge of the contain-
er is level with the marking on the handle.
■
Remove the residual solder pot, as described in Chap-
ter 8.3.1.
■
Remove the filter plug from the residual solder pot.
■
Remove the lid of the residual solder pot with a rotary
motion.
■
Clean the residual solder pot e.g. with the Ersa clean-
ing brush, order no. 3N090.
■
Insert a new filter plug. It must be pushed backwards
up to the narrowing of the residual solder pot ①.
■
Close the residual solder pot again.
ersa X-TOOL VARIO