Maintenance - Carrier XCT7 Installations- Und Benutzerhandbuch

Maintenance

*The air cleaner should be cleaned only when it is switched off and disconnected from the power supply, otherwise
electric shock and injury may appear.
Cleaning the air outlet port and the shell:
• Do not use gasoline, benzene, diluents, polishing powder or liquid insecticide to clean them.
• Do not clean them with hot water of above 5O°c to avoid fading or distortion.
• Wipe them with soft dry cloth.
• Water or neutral dry cleanser is recommended if the dust cannot be removed.
Cleaning filter
• Do not clean with hot water of over 50°C to avoid fading or distortion.
• Do not dry on the fire, or the cleaner might cause fire.
• Cleaning
Clean the air cleaner with a vacuum cleaner or water to remove dust.
If there is too much dust, use the fan or directly spray the special cookware detergent on the air
inlet grid, and then clean it with water after 10 minutes.
(A) remove dust with a vacuum cleaner.
Attention
Attention
(B) for excessive dust, use a soft-hair brush and a
mild detergent to clean.
(C) Allow filter to dry fully before reinstalling.
4