Attaching The Blade Spur; Attaching The Front Wheel - Stihl MH 600 Gebrauchsanleitung

6 Assembling the Cultivator
► Push folding retainers (3) through the bores in drive
shaft (2) and close the securing clips.
Hoes (1) are secured.
6.1.2 Removing the Hoes
► Stop the engine.
► Pull out the folding retainers.
► Remove the hoes.
► Push the folding retainers through the bores in the drive
shaft.
The folding retainers are kept in place.
6.2

Attaching the Blade Spur

► Screw nuts (1) onto bolts (2) and screw into the bores in
adapter (3).
► Fit blade spur (4) into adapter (3) from below so the bores
on adapter (3) align with the lowermost bore on blade
spur (4).
► Insert pin (5).
► Push retaining pin (6) through the bore in pin (5).
0478-404-9807-A
► Insert the adapter with attached blade spur (7) into
mount (8) on the tiller.
► Insert pin (9).
► Push retaining pin (10) through the bore in pin (9).
The blade spur is secured.
6.3

Attaching the Front Wheel

► Slide front wheel (1) onto frame (2) so the bores align.
► Insert bolt (3) into the rear bore.
► Place washer (4) on bolt (3).
► Screw on nut (5) and tighten.
English
49