Cleaning; Cleaning The Tiller; Cleaning The Hoes; Maintenance - Stihl MH 600 Gebrauchsanleitung

15 Cleaning

► Remove the hoes.
► Open the fuel tank cap.
► Empty the fuel tank.
► Seal the fuel tank.
► Have the fuel tank cleaned by a STIHL specialist dealer.
► Start the engine and leave it idling until it cuts out.
15 Cleaning

15.1 Cleaning the Tiller

► Stop the engine.
► Allow the tiller to cool down.
► Clean the tiller with a damp cloth or STIHL resin solvent.
► Clean the ventilation slots with a paintbrush.
► Spray the drive shaft with STIHL multispray.

15.2 Cleaning the Hoes

► Stop the engine.
► Allow the tiller to cool down.
► Place the front wheel in the operating position.
► Set the handlebar to the lowest level.
► Detach retaining pin (1) and remove pin (2).
0478-404-9807-A
► Remove the blade spur together with adapter (3).
► Rest the tiller on the handlebar and do not leave in the
position for longer than it takes to clean it.

16 Maintenance

16.1 Maintenance Intervals

Maintenance intervals are dependent on the ambient
conditions and the working conditions. STIHL recommends
the following maintenance intervals:
Engine and oil bath air filter
► Maintain the engine and oil bath air filter as described in
the engine instruction manual.
Before each use:
► Check the gearbox oil level.
After the first month or after 20 operating hours:
► Change the gearbox oil.
Every 6 months or after 100 operating hours:
► Change the gearbox oil.

16.2 Lubricating the Gearbox

► Stop the engine.
► Place the tiller on a level surface.
English
63