Attaching The Front Wheel; Attaching The Blade Spur - Stihl MH 700 Gebrauchsanleitung

English
► Push folding retainers (9) through the bores in drive
shaft (8) and close the securing clips.
Running wheels (7) are secured.
6.2.2 Removing the Running Wheels
► Stop the engine.
► Pull out the folding retainers.
► Remove the running wheels.
► Push the folding retainers through the bores in the drive
shaft.
The folding retainers are kept in place.
6.3

Attaching the Front Wheel

► Slide front wheel (1) into frame (2) so the bores align.
► Insert bolt (3) into the upper bore.
► Place washer (4) on bolt (3).
► Screw on nut (5) and tighten firmly.
► Insert pin (6) through the lower bore.
► Push retaining pin (7) through the bore in pin (6).
Pin (6) is secured and front wheel (1) is locked in position.
The front wheel must not be dismantled again.
56
6.4

Attaching the Blade Spur

Assembling the blade spur
► Screw nuts (1) onto bolts (2) and screw into the bores in
adapter (3).
► Fit blade spur (4) into adapter (3) from below so the bore
on adapter (3) aligns with the lowermost bore on blade
spur (4).
► Insert pin (5).
► Push retaining pin (6) through the bore in pin (5).
The blade spur is secured.
6 Assembling the Cultivator
0478-404-9604-A