Preparing Special Harvester For Operation; Charging The Battery, Leds; Displaying State Of Charge; Assembling The Special Harvester - Stihl SPA 65 Gebrauchsanleitung

English
► Move the retaining latch to the
► Remove the battery.
■ Harsh detergents, cleaning with a water jet or
sharp objects can damage the special har‐
vester, the rakes and the battery. If the special
harvester, rakes or battery are not cleaned
correctly, components may no longer function
properly or safety devices may be rendered
inoperative. They may cause serious injury to
persons.
► Clean the special harvester, rakes and bat‐
tery as described in this instruction manual.
■ If the special harvester, rakes or battery are
not serviced correctly, components may no
longer function properly or safety devices may
be rendered inoperative. This may result in
serous or fatal injury to people.
► Do not attempt to service or repair the spe‐
cial harvester, rakes or battery.
► If the special harvester, the rakes and the
battery require servicing or repairs: contact
your STIHL dealer for assistance.
5 Preparing Special Har‐
vester for Operation
5.1 Preparing Special Harvester for
Operation
The following steps must be performed before
commencing work:
► Ensure that the following components are in
safe condition:
– Special harvester,
– Rakes, 4.6.2.
– Battery, 4.6.3.
► Check the battery,
► Fully charge battery as described in the User
Manual for chargers STIHL AL 101, 300, 500.
► Clean the special harvester,
► Fit the tines,
7.1.1.
► Mount the machine support,
► Fit and adjust the carrying system,
► Check the controls,
► If you cannot carry out these steps: Do not use
your special harvester and contact your STIHL
servicing dealer for assistance.
24
position.
4.6.1.
11.2.
16.1.
7.2.
8.
11.

5 Preparing Special Harvester for Operation

6

Charging the Battery, LEDs

6.1 Charging the Battery
The charging time depends on several factors,
e.g. temperature of the battery or the ambient
temperature. The actual charging time may differ
from the specified charging time. For specified
charging times see www.stihl.com/charging-
times.
► Recharge the battery fully as described in the
instruction manual for the STIHL AL 101, 300,
500 chargers.
6.2

Displaying State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3 LEDs on Battery
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
18.
There is a malfunction in the special harvester
or battery.
7 Assembling the Special
Harvester
7.1 Fitting and Removing the Tines
7.1.1 Fitting the Tines
► Switch off the special harvester, push retaining
latch to position and remove the battery.
80-100%
60-80%
40-60%
20-40%
0-20%
0458-704-9921-D