Operation - Hendi 3500 Bedienungsanleitung

The control panel
1. "ON/OFF" key: Use this key to switch the appli-
ance on or to interrupt or reset the timer.

Operation

• Put the plug in the socket.
• Set the pan of your choice on the cooking sur-
face, bearing the above-mentioned instructions
in mind.
NOTE! Do not leave your pan on the burner while
empty as this may lead to damage to your pans.
• Switch the appliance on :
EN
Error codes display
Error codes shown on the
display (5)
E01
E02
E03
6
Display
Adjust setting down
Possible cause
The temperature of the appliance is too high
Cooling fan defective
The temperature of the cookware is too high.
Possibly, the cookware becomes empty and
appliance will shut down for protection.
The supply voltage is abnormal. (Supply volt-
age is too high or too low)
ON/OFF
Adjust setting up
2. "Arrow" keys: Use these keys for programming the
capacity. The up arrow increases the setting value
and the down arrow reduces the setting value.
• NOTE! This appliance can only be used in combi-
nation with wok pan 239773.
• Now you can programme the capacity required by
means of the arrow keys, 3500W being the high-
est and 500W the lowest position.
• Once you have reached the required result, you
can switch off the appliance by pressing the "ON/
OFF" key. The display will go off
• If you do not use the appliance for an extended
period, remove the plug from the electrical sock-
et and remove the pan from the appliance.
NOTE! Allow the appliance to cool off before you
touch it. The ceramic plate is very hot after use.
Possible solution
Unplug the appliance, remove the cook-
ware, wait until the appliance is com-
pletely cool down.
Contact the supplier.
Unplug the appliance, remove the cook-
ware, wait until the appliance is com-
pletely cool down.
Make sure that the appliance is connect-
ed to a suitable electrical power supply.